Rank: Member
Groups: Member
Joined: 5/10/2012(UTC) Posts: 3 
|
Greetings,I have completed my buffalo III build but upon start up was met with eery silence.I'm using the single SPDIF-TTL input board and have it connected directly to DIN 2 .I have comfirmed the board is recieving 5.2 volts and Tridents are working.I gather from the manual all the DIP switches should be in the off position?Assuming this is so what might I be over looking?
Thanks
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
Are you getting a lock (lock led lighting)?
If so, do you have either the volume pot installed, or the jumper in place?
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 5/10/2012(UTC) Posts: 3
|
No lock LED and jumper installed.
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
If you are using input #2, you need to select it via dip switch. Off the top of my head, I think it it SW2:1 on.
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 5/10/2012(UTC) Posts: 3
|
Thanks Brian that did it.Now I just have to track down why I don't have any output on the R ch.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
