Welcome Guest! To enable all features please Login or Register.



Go to last post Go to first unread
#1 Posted : Friday, March 14, 2008 4:05:45 PM(UTC)

Rank: Member

Groups: Member
Joined: 7/13/2007(UTC)
Posts: 27
Location: Tacoma, WA

When running the power wires (analog and dig) from the PSU to the dac+ stack, do I have to run 3 seperate runs of wire (6 pairs) from the PSU to each component? Or, can I just run 1 set each and jumper from one to the other at the dac side? Or would this cause problems?

Thank you
Brian Donegan  
#2 Posted : Friday, March 14, 2008 4:11:56 PM(UTC)
Brian Donegan

Rank: Administration

Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,849
Location: Massachusetts, USA

Thanks: 2 times
Was thanked: 135 time(s) in 130 post(s)
You might be able to get away with one run and daisy-chaining, but it's hard to tell as it depends on a lot of smaller factors. It is so much fast to do however, that it's worth a shot, so try it. If you seems to have any noise problems, you can just remove the daisy chains and add two more runs.

That said, that advantage of individual runs is that the terminal block acts like a power star point, so noise generated by one module is not shared with the other modules directly.
Rss Feed  Atom Feed
Users browsing this topic
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.