Twisted Pear Audio Support
»
Product Support
»
General Questions
»
Possible to measure volume directly on the b3 board?
Rank: Member
Groups: Member
Joined: 9/23/2015(UTC) Posts: 89  Thanks: 5 times
|
I want to start programming the b3.
Is it possible to measure the change in volume directly on the b3 board?
I would like to avoid putting the whole system together just to be able to hear volume change on my speakers.
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
Your best bet when controlling the DAC with the I2C bus is to write a register, then read the register value back to verify its value. This is good practice with all registers, not just volume.
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 9/23/2015(UTC) Posts: 89 Thanks: 5 times
|
Thank you. I will of course do that.
But I was thinking more of a measurable way of confirming that the registry settings have the desired effect.
Or do i have to hook up the system and speakers?
|
|
|
|
|
|
Twisted Pear Audio Support
»
Product Support
»
General Questions
»
Possible to measure volume directly on the b3 board?
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
