Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error

Login


Options
View
Go to last post Go to first unread
evlah  
#1 Posted : Sunday, May 11, 2014 1:37:01 PM(UTC)
evlah

Rank: Member

Groups: Member
Joined: 11/3/2013(UTC)
Posts: 2
Greece

Hello,

I cannot trim the DC offset on the right Balanced output of the Legato 3.1.
I am getting approximately .5V (does not vary with trim pot) when I connect it to the Buffalo III.
Replaced all fets and transistors, reworked board looking for cold solder joints but problem still persists.
SE output can be trimmed no problem.
I am getting 8.9V -toGND and 9.4V +toGND.
It trims to zero fine without Buffalo connected.
Any ideas?

Thanks,
Evan
evlah  
#2 Posted : Sunday, May 11, 2014 2:31:39 PM(UTC)
evlah

Rank: Member

Groups: Member
Joined: 11/3/2013(UTC)
Posts: 2
Greece

0.5V on J6 to GND not on J5 (jumpers not installed) stock parts and gain.
Circuit was zeroing fine until I started probing around....

Edited by user Wednesday, May 14, 2014 6:53:53 PM(UTC)  | Reason: added details

Rss Feed  Atom Feed
Users browsing this topic
GuestUser
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.