Rank: Member
Groups: Member
Joined: 8/6/2011(UTC) Posts: 9 Location: Poland
|
Hello, i have the Buffalo III DAC with Legato 3.1 (with buffers) Sounds awesome. I try to use it with my 250 Ohm headphones but maximum volume level is slightly too low for me. It is a solution to increase it? Thanks in advance.
|
|
|
|
Rank: Member
Groups: Member
Joined: 5/23/2010(UTC) Posts: 708 Location: Netherlands
Thanks: 2 times Was thanked: 48 time(s) in 45 post(s)
|
I take it you connect them to the SE outputs? If you just use your headphones on those, you could try to lower resistance for the resistors R17-R20 of the Legato. This increases the gain of the SE stage.
|
|
|
|
Rank: Administration
Groups: Administration, Customer Joined: 10/24/2006(UTC) Posts: 3,979 Location: Nashville, TN
Thanks: 25 times Was thanked: 89 time(s) in 83 post(s)
|
Actually it is better to leave value of R17-R20 (because this effects the offset adjustment). Though honestly the approach of lowering them is OK. To be certain you still get good offset adjustment, I would try doubling the feedback resistors R21-R24 instead. Say 10K. Edited by user Monday, October 10, 2011 10:33:18 AM(UTC)
| Reason: Not specified
|
|
|
|
Rank: Member
Groups: Member
Joined: 8/6/2011(UTC) Posts: 9 Location: Poland
|
I use 16,2k value of R21-24 finally. Now Legato is powerful with my Beyerdynamic's. Very powerful :-). Thanks a lot! Edited by user Thursday, October 13, 2011 3:43:46 PM(UTC)
| Reason: Not specified
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.