Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error

Login


Options
View
Go to last post Go to first unread
johnmarkp  
#1 Posted : Sunday, February 12, 2012 9:08:46 AM(UTC)
johnmarkp

Rank: Member

Groups: Member
Joined: 2/12/2012(UTC)
Posts: 3
Location: Milwaukee

I asked the question below.

I found out that there is a mistake on the PCB. The right channel negative output is missing the trace that connects the two pads. I am using the outer one that is connected to the circuit the inner pad is not connected to the outer. So of course I was not able to measure anything using it. The pads are connected properly on the other outputs. I am not sure if this is documented anywhere.


I just finished building a Legato III. I was able to easily zero out the left channel outputs measuring between the - and + outputs. I can not get the right channel to zero out. The value starts at 100mv and drifts all over the place. Turning the trim pot does bring it down some, but the it drifts back up. I am not using output caps. I will pull the test rig apart and see if I can find the usual suspects, cold solder joints etc. Is there something in particular I should be looking for?

Thanks

Edited by user Sunday, February 12, 2012 9:33:38 AM(UTC)  | Reason: Not specified

johnmarkp attached the following image(s):
Right.JPG (36kb) downloaded 61 time(s).
Left.JPG (62kb) downloaded 56 time(s).

You cannot view/download attachments. Try to login or register.
Brian Donegan  
#2 Posted : Tuesday, February 14, 2012 1:51:12 PM(UTC)
Brian Donegan

Rank: Administration

Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA

Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
Can you post a picture of this?
Rss Feed  Atom Feed
Users browsing this topic
GuestUser
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.