Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error

Login


Options
View
Go to last post Go to first unread
JohnG  
#1 Posted : Monday, December 19, 2016 6:06:52 PM(UTC)
JohnG

Rank: Member

Groups: Member
Joined: 9/6/2016(UTC)
Posts: 16

I need to add the output buffers. Do I need a hot air soldering station for that (so that the heatsink solders) or can I just solder the pins with an iron? I dont have a hot air, so Id have to find one to borrow or use a toaster oven

Im converting from a single setup, where I wasn't using the buffers, now to a dual.

Thanks, John
Russ White  
#2 Posted : Tuesday, December 20, 2016 3:01:56 PM(UTC)
Russ White

Rank: Administration

Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN

Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
It is not strictly necessary to use hot air, but it does make the job easier.

You can use a soldering iron, just do the big tab last - it is not necessary to achieve complete wetting under the tab - but at least make sure it is soldered to the pad.

Cheers!
Russ
JohnG  
#3 Posted : Tuesday, December 20, 2016 6:15:31 PM(UTC)
JohnG

Rank: Member

Groups: Member
Joined: 9/6/2016(UTC)
Posts: 16

Thanks.
JohnG  
#4 Posted : Saturday, January 14, 2017 8:44:41 PM(UTC)
JohnG

Rank: Member

Groups: Member
Joined: 9/6/2016(UTC)
Posts: 16

I did solder them on. Now, I have one Legato that seems fine, but the other one is odd.

Connected to a Placid BP HD (which is set and works for the other Legato), this one starts out with only 3v on one side and 5 on the other.

Then, I raise the shunt current (either side - it doesnt seem to matter) and at some point I hear a click and the voltage jumps up to the 14.75 it is set for.

Uplug it, wait a min and plug it back in, and now I have to crank up the shunt current again (above what it was before).

Ive swapped Placids and Legatos and it seems to be this one Legato.

Could I have overheated the buffers? Ive checked the solder joints on them. And looked at the transistors to make sure I didnt swap them.

Thanks, John
Brian Donegan  
#5 Posted : Thursday, January 19, 2017 4:39:05 PM(UTC)
Brian Donegan

Rank: Administration

Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA

Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
Compare pin-to-pin resistance of the working and non-working buffers. That should tell you if you cooked something (look for shorts).

I assume the non-functioning Legato was functioning correctly before adding the buffers...
Rss Feed  Atom Feed
Users browsing this topic
GuestUser (2)
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.